PneumaticPlus Dryspell Plus 100 Heatless Regenerative Desiccant Air Dryer includes Pre and After Filters - 100 cfm, 1" NPT 

Drying Cycle

Moist air from the compressor is sent through the coalescing filter. Here water & oil coalesces, gets purged through the auto drain valve. The relatively clean air with water vapor passes through the aluminum drying tower filled with desiccant, gets completely dried (up to -40F PDP), and then passes through a built in after filter. The desiccant fines from the towers are completely removed and clean dry air is let out through the outlet port for use.

Regeneration Cycle

During the regeneration cycle, the sudden depressurization brings out water molecules trapped in the desiccant pores to the surface of the beads. A small portion of dry compressed air from the drying tower then passes over the desiccant through the regeneration orifice built in the Top Block. This results in complete regeneration of the desiccant.

Specifications

• Maximum Operating Pressure : 232 PSI (g) (16 kg/cm2 (g))
• Rated Air Inlet Temperature : 100F Max (380C)
• Operating Pressure :  101.5 PSI (g) (7 kg/cm2 (g))
• Recommended Pre-Filter Rating : 0.01 Microns
• Cycle Time : 4 Minutes
• Operating Voltage : 100-240 VAC 50/60 Hz 1 Ph
• Outlet Conditions : Dry air at -40F PDP*
• Purge Loss : 15±1%
• Flow Rate : 100 cfm 
• End Connection : 1" NPT
  
  * ISO 8573-1 2010(E) Class -2-

 Techincal Catalog Download           Spec Catalog Download